Tuesday, August 2, 2011

P0505 ON 2004 MERCURY MOUNTAINEER 4.6?

This is for both 4.6 and 4.0L—DTC—P0505 / P0506 / HESITATION / LOSS OF TSB 09-4-2
RPM / DIFFICULTY STARTING / LOW IDLE RPM.-------
But in most of the 4.0 it was noticed, so 4.0 l is only mentioned.-----------

Click this link and go through the service bulletin:--
--------
Also click this link :---


--------------
Get consult with your local ford dealer.If your car is considered under service , then this problem will be repaired for free.Or at least with no labor cost, only part cost.--------

P0505 FORD Description:--
This system automatically controls engine idle speed to a specified level. Idle speed is controlled through fine adjustment of the amount of air which by-passes the throttle valve via Idle Air Control Valve IACV) and Auxiliary Air Control AAC) Valve. The IACV-AAC valve changes the opening of the air by-pass passage to control the amount of auxiliary air. This valve is actuated by a step motor built into the valve, which moves the valve in the axial direction in steps corresponding to the ECM output signals.

One step of IACV-AAC valve movement causes the respective opening of the air by-pass passage. (i.e. when the step advances, the opening is enlarged.) The opening of the valve is varied to allow for optimum control of the engine idling speed. The crankshaft position sensor (POS) detects the actual engine speed and sends a signal to the ECM. The
ECM then controls the step position of the IACV-AAC valve so that engine speed coincides with the target value memorized in ECM. The target engine speed is the lowest speed at which the engine can operate steadily. The optimum value stored in the ECM is determined by takig into consideration various engine conditions, such as during warm up, deceleration, and engine load (air conditioner, power steering and cooling fan operation).

max