Friday, October 28, 2011

Water pump removal instructions for 2003 Ford Focus?

Replacing water pump also requires removal of timing belt,drive accessory belt,timing belt tensioner etc etc.
So please go through this procedures too.Then only it will help you to replace water pump.

Accessory Drive Belt removal on 2003 Ford Focus?

Click the link below:--

How to remove Timing Belt on 2003 Ford Focus?

Click the link below:--


Replacing Timing Belt Tensioner on 2003 Ford Focus?



WATER PUMP 

Removal & Installation



2.0L (VIN 3) Engines



  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Drain the cooling system.
  3. Remove or disconnect the following:

    Negative battery cable
    Accessory drive belt
    Water pump pulley
    Front cover
    Timing belt
    Timing belt tensioner
    Water pump
To install:
  1. Install or connect the following:

    Water pump. Tighten the bolts to 13 ft. lbs. (18 Nm).
    Timing belt tensioner
    Timing belt
    Front cover
    Water pump pulley
    Accessory drive belt
    Negative battery cable
  2. Fill the cooling system.
  3. Start the engine and check for leaks.

2.0L (VIN N) Engine And 2.3L (VIN Z) Engine



  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Drain the cooling system.
  3. Remove or disconnect the following:

    Negative battery cable
    Accessory drive belt
    Water pump pulley
    Water pump mounting bolts
    Water pump
To install:
  1. Install or connect the following:

    Water pump with new O-ring. Tighten the bolts to 89 inch lbs. (10 Nm).
    Water pump pulley. Tighten the bolts to 18 ft. lbs. (25 Nm).
    Accessory drive belt
    Negative battery cable
  2. Fill the cooling system to the correct level.
  3. Start the engine and check for leaks.
  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Drain the cooling system.
  3. Remove or disconnect the following:

    Negative battery cable
    Accessory drive belt
    Water pump pulley
    Water pump mounting bolts
    Water pump
To install:
  1. Install or connect the following:

    Water pump with new O-ring. Tighten the bolts to 89 inch lbs. (10 Nm).
    Water pump pulley. Tighten the bolts to 18 ft. lbs. (25 Nm).
    Accessory drive belt
    Negative battery cable
  2. Fill the cooling system to the correct level.
  3. Start the engine and check for leaks.

2.0L (VIN P) Engine



  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Drain the cooling system.
  3. Remove or disconnect the following:

    Negative battery cable
    Accessory drive belt
    Front cover
    Timing belt
    Timing belt tensioner
    Water pump
To install:
  1. Install or connect the following:

    Water pump. Tighten the bolts to 18 ft. lbs. (25 Nm).
    Timing belt tensioner
    Timing belt
    Accessory drive belt
    Negative battery cable
  2. Fill the cooling system.
  3. Start the engine and check for leaks.


-------------

max