Wednesday, October 19, 2011

How to replace blower motor on Chevrolet Tracker?

Blower motor removal for 1998 Chevrolet Tracker.
The instructions are as follows :--


Blower Motor


Sidekick, Tracker, Sidekick Sport and X-90 Models
See Figures 3 and 4
  1. Disconnect the negative battery cable.
  2. On models with air bags, disable the system.
  3. Remove the glove box assembly by opening it, and loosening the pivot and retaining screws from inside the glove box with a screwdriver.


Click image to see an enlarged view
Fig. Fig.3: Exploded view of the blower motor mounting in the heater case
  1. On 1996-98 models, remove the instrument panel assist holder (lower brace).
  2. Remove the relays and relay bracket from the blower motor case.
  3. Disengage the blower motor and resistor wire connectors.
  4. Disconnect the fresh air control cable from the blower motor case.
  5. Remove the 3 blower motor mounting screws.
  6. Remove the blower motor.


Click image to see an enlarged view
Fig. Fig. 4: To remove the blower motor, open the glove box and loosen the box pivot and retaining screws ...


Click image to see an enlarged view
Fig. Fig. 5: ... then remove the glove box from the instrument panel


Click image to see an enlarged view
Fig. Fig. 6: From beneath the instrument panel, detach the wiring harness connectors ...


Click image to see an enlarged view
Fig. Fig. 7: ... and hoses from the blower motor


Click image to see an enlarged view
Fig. Fig. 8: Blower motor mounting bolt locations on the bottom of the heater case


Click image to see an enlarged view
Fig. Fig. 9: Loosen all of the blower motor-to-heater case assembly mounting bolts ...


Click image to see an enlarged view
Fig. Fig. 10: ... then lower the blower motor out of the heater case assembly
To install:
  1. Install the blower motor and secure with the 3 screws.
  2. Connect the fresh air control cable to the blower motor case.
  3. Connect the electrical connectors and install the glove box assembly.
  4. Install the relay bracket and relays on the blower motor case.
  5. On 1996-98 models, install the instrument panel assist holder.
  6. Connect the negative battery cable.
  7. If applicable, enable the air bag system.
  8. Check for proper blower motor operation.

----------------
If you want to know

How to replace Heater core on Chevrolet Tracker?

Click the link below:---

--------------
If you want to know

How to replace Control Panel on Chevrolet Tracker?

Click this link below:---
---------