Friday, December 9, 2011

How to Remove Timing Chain Cover and Seal on Toyota Previa?

The details and diagram below will guide you for this procedure.


REMOVAL & INSTALLATION



  1. Disconnect the negative battery cable. Wait at least 90 seconds after the negative battery cable is disconnected before performing work on models equipped with an airbag.

CAUTION
Some models covered by this guide may be equipped with a Supplemental Restraint System (SRS), which uses an air bag. Whenever working near any of the SRS components, such as the impact sensors, the air bag module, steering column and instrument panel, disable the SRS, as described in Chassis Electrical .

  1. Remove the engine from the vehicle.
  2. Remove the cylinder head from the engine.
  3. Remove the crankshaft pulley and damper.
  4. Unbolt and remove the left engine mounting.
  5. Remove the oil pressure switch and engine ventilation case.
  6. Extract the engine oil dipstick. Remove the No. 2 engine hanger.
  7. If equipped, remove the crankshaft position sensor.
  8. Remove the 16 bolts and 2 nuts retaining the oil pan. To separate, insert a pry tool and carefully tap it with a brass bar.
  9. Remove the No. 2 oil dipstick guide and oil baffle plate.
  10. Remove the 3 bolts and oil filter bracket from the timing cover.
  11. Remove the 12 bolts, 2 nuts and timing cover.
There are 3 bolts located in back of the cover. Be careful not to damage the mating surfaces during removal.
To install:
  1. Before installing, clean all gasket surfaces and check for warpage.
  2. Install the timing chain cover using a new gasket. Tighten the following bolts:

    A-14 ft. lbs. (21 Nm)
    B-21 ft. lbs. (28 Nm)
    C-32 ft. lbs. (43 Nm)
  3. Install the oil filter bracket and tighten to 14 ft. lbs. (21 Nm).
  4. Install the crankcase baffle plate, oil pan, No. 1dipstick tube guide and ventilation case. Tighten the baffle plate to 43 inch lbs. (5 Nm), oil pan bolts to 9 ft. lbs. (13 Nm), ventilation case to 69 inch lbs. (8 Nm) and the No. 1 dipstick tube guide to 22 ft. lbs. (29 Nm).
  5. Attach the No. 2 engine hanger to the block and tighten to 27 ft. lbs. (37 Nm).
  6. Ibnstall the engine oil dipstick and secure.
  7. Install the oil pressure switch, left engine mount and stay. Tighten the left engine mount bolts to 30 ft. lbs. (41 Nm) and stay bolts to 27 ft. lbs. (37 Nm).
  8. Install the crankshaft pulley and tighten the bolt to 192 ft. lbs. (260 Nm).
  9. Install the cylinder head and engine assembly into the vehicle.
  10. Install the remaining components and check for leaks.
Seal replacement
See Figures 1, 2, 3 and 4
There are two methods of replacing the oil seal depending on weather the oil pump cover is assembled to the engine or not.
If the oil pump is not installed to the timing chain case, use a flatbladed tool and rag to pry the old seal out. Apply multipurpose grease to the new oil seal lip. Using a seal installer, tap the seal into place.


Click image to see an enlarged view
Fig. Fig. 1: Place a rag over the retainer and carefully pry the seal out


Click image to see an enlarged view
Fig. Fig. 2: Install the seal using the proper sized driver
If the oil pump is installed on the timing chain case, use a knife to cut off the lip of the seal and pry it out. Check the oil seal lip contact surface of the crankshaft for cracks or damage. Apply multi-purpose grease to the new oil seal lip. Using a seal installer, drive the new seal flush against the cover edge.


Click image to see an enlarged view
Fig. Fig. 3: Carefully cut off the oil seal lip, then pry the seal from the cover


Click image to see an enlarged view
Fig. Fig. 4: Drive the seal flush against the cover edge





This basic details will help.Thanks.
------------------
If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.


For all types of

Timing belt routing diagrams for cars and trucks?

Click the link below:---

For all types of 

Drive belt routing diagrams for cars and trucks?

Click the link below:---

Replacing Timing belt on Toyota Tercel?


How to replace Timing Belt Cover on Acura Car models?


How to replace Timing Belt and Sprockets on Acura Car models?


How to replace Timing Belt on Audi and VW car models?


How to replace Timing Belt Cover on Audi and VW car models?


How to replace Timing Belt Sprockets on Audi car models?

http://repairhelpcenter.blogspot.com/2011/11/how-to-replace-timing-belt-sprockets-on.html

How the timing marks on valve pulleys line up with crank on 1997 Dodge Intrepid?

Timing belt Replacing procedure for Daewoo Nubira?

Replace Drive Belt on 2003 Hyundai Tiburon?

http://carbeltrouting.blogspot.com/2011/12/replace-drive-belt-on-2003-hyundai.html

2003 Volkswagen Passat Drive belt routing for all engines?

http://carbeltrouting.blogspot.com/2011/12/2003-volkswagen-passat-drive-belt.html

Serpentine Belt Route Diagram for 2004 Chevrolet Express?

http://carbeltrouting.blogspot.com/2011/12/serpentine-belt-route-diagram-for-2004.html

2005 Toyota Tacoma serpentine belt diagram?

http://carbeltrouting.blogspot.com/2011/12/2005-toyota-tacoma-serpentine-belt.html

Ford Super Duty F 450 drive belt routing diagram?

http://carbeltrouting.blogspot.com/2011/12/ford-super-duty-f-450-drive-belt.html

2004 Ford Truck F450 Super Duty P/U 4WD 6.0L Turbo Diesel 8cyl Serpentine belt routing?

http://carbeltrouting.blogspot.com/2011/12/2004-ford-truck-f450-super-duty-pu-4wd.html

2006 Ford Mustang Serpentine belt routing?

http://carbeltrouting.blogspot.com/2011/12/2006-ford-mustang-serpentine-belt.html

Jaguar S-Type Belt routing diagram?

http://carbeltrouting.blogspot.com/2011/12/jaguar-s-type-belt-routing-diagram.html

Drive Belt replacing on 2001 hyundai xg300?

http://carbeltrouting.blogspot.com/2011/12/drive-belt-replacing-on-2001-hyundai.html

2002 FORD TRUCK WINDSTAR Serpentine belt routing?

http://carbeltrouting.blogspot.com/2011/12/2002-ford-truck-windstar-serpentine.html

Fan belt routing diagram for 2004 Volkswagen Jetta?

http://carbeltrouting.blogspot.com/2011/12/fan-belt-routing-diagram-for-2004.html

Chevy Duramax Belt routing?

http://carbeltrouting.blogspot.com/2011/12/chevy-duramax-belt-routing.html

1992 Ford Aerostar Power steering and Alternator belt routing diagram?

http://carbeltrouting.blogspot.com/2011/12/1992-ford-aerostar-power-steering-and.html

Jeep Wrangler drive belt diagram?

http://carbeltrouting.blogspot.com/2011/12/jeep-wrangler-drive-belt-diagram.html

How to route the serpentine belt?

http://carbeltrouting.blogspot.com/2011/12/how-to-route-serpentine-belt.html

2000 Ford windstar serpentine belt Replacing diagram?

http://carbeltrouting.blogspot.com/2011/12/2000-ford-windstar-serpentine-belt.html

1994 Mercedes-Benz C 280 Drive Belt Routing?

http://carbeltrouting.blogspot.com/2011/12/1994-mercedes-benz-c-280-drive-belt.html

2002 Chevrolet Truck Trailblazer Accessory Belt Diagram?

http://carbeltrouting.blogspot.com/2011/12/2002-chevrolet-truck-trailblazer.html

Ford Escort Serpentine Engine Belt Routing Diagram?

http://carbeltrouting.blogspot.com/2011/12/ford-escort-serpentine-engine-belt.html

2000 Chevrolet Cavalier Serpentine belt routing directions?

http://carbeltrouting.blogspot.com/2011/12/2000-chevrolet-cavalier-serpentine-belt.html

How to route new serpentine belt on Mazda B3000?

http://carbeltrouting.blogspot.com/2011/12/how-to-route-new-serpentine-belt-on.html

Dodge cummins 5.9L diesel engine drive belt routing?

http://carbeltrouting.blogspot.com/2011/12/dodge-cummins-59l-diesel-engine-drive.html

2005 Dodge Dakota 3.7 Drive belt routing?

http://carbeltrouting.blogspot.com/2011/12/2005-dodge-dakota-37-drive-belt-routing.html

Drive belt came off while driving?

http://carbeltrouting.blogspot.com/2011/12/drivebelt-came-off-while-driving.html

2003 Ford Focus Drive belt Routing Diagram?

http://carbeltrouting.blogspot.com/2011/12/2003-ford-focus-drive-belt-routing.html

1997 PONTIAC BONNEVILLE Serpentine belt routing Diagram?

http://carbeltrouting.blogspot.com/2011/12/1997-pontiac-bonneville-serpentine-belt.html

BMW 330CI alternator belt routing diagram?

http://carbeltrouting.blogspot.com/2011/12/bmw-330ci-alternator-belt-routing.html

2004 ford f-150 serpentine belt routing?

http://carbeltrouting.blogspot.com/2011/12/2004-ford-f-150-serpentine-belt-routing.html

How to route Water Pump Belt for 1992 Oldsmobile Cutlass Ciera?

http://carbeltrouting.blogspot.com/2011/12/how-to-route-water-pump-belt-for-1992.html

How to release Accessory drive belt on GMC Envoy 4.6L engine?

Proper timing marks for the DOHC 3.0 liter engine?

http://schematicsdiagram.blogspot.com/2011/12/proper-timing-marks-for-dohc-30-liter.html


max