Friday, December 9, 2011

How to Remove Water Pump on Toyota Previa?

Water pump is very important part.
The details to replace Toyota water pump is as follows :---------

REMOVAL & INSTALLATION



See Figures 1 through 10



image
Fig. Fig. 1: View of the water pump and related components
  1. Raise the vehicle and support safely.
  2. Remove the engine under covers.
  3. Drain the engine coolant.
  4. Drain the engine oil.
  5. Disconnect the heater hose and radiator outlet hoses.
  6. Remove the oil filter bracket.


Click image to see an enlarged view
Fig. Fig. 2: Unbolt and remove the oil filter bracket


Click image to see an enlarged view
Fig. Fig. 3: Remember to discard the old gasket for the bracket
  1. Disconnect the water hose from the water pump.


Click image to see an enlarged view
Fig. Fig. 4: Remove any hoses attached to the water pump
  1. Remove the water pump retaining bolts and pump from the timing cover.


Click image to see an enlarged view
Fig. Fig. 5: Remove any bolts attaching the water pump to the engine


Click image to see an enlarged view
Fig. Fig. 6: Extract the pump from the block


Click image to see an enlarged view
Fig. Fig. 7: Location and sizes of all water pump bolts
  1. Remove the O-ring from the water pump.


Click image to see an enlarged view
Fig. Fig. 8: Remove all the o-rings from the water pump area
  1. Remove the water pump from the housing by removing the two bolts.


Click image to see an enlarged view
Fig. Fig. 9: View of the water pump gasket mating area
To install:
  1. Install the water pump with a new gasket and tighten the bolts to 14 ft. lbs. (20 Nm).
  2. Install the water pump to the timing cover and install the bolts. Tighten the bolts for the water pump as follows:

    Bolt A: 14 ft. lbs. (20 Nm)
    Bolt B: 21 ft. lbs. (28 Nm)


Click image to see an enlarged view
Fig. Fig. 10: Waterpump bolt identification
  1. Connect the water hose to the water pump.
  2. Install the oil filter bracket to the engine using a new O-ring.
  3. Connect the heater hose and radiator outlet hose.
  4. Fill the engine with oil.
  5. Fill the engine and radiator with coolant.
  6. Start the engine and check for leaks.

---------------

This basic details will help.Thanks.
------------------
If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.


For more water pump related details,see the list below:---

How to route Water Pump Belt for 1992 Oldsmobile Cutlass Ciera?

http://carbeltrouting.blogspot.com/2011/12/how-to-route-water-pump-belt-for-1992.html