Friday, January 27, 2012

How to replace Brake Caliper on Kia Sportage?

The details are as follows :----


Removal & Installation



  1. Raise and safely support the vehicle.
  2. Remove the front wheels.
  3. Remove the 2 caliper bolts and lift the caliper from the disc.
  4. Disconnect the brake fluid flex line by removing the retaining bolt if the caliper is to be replaced.
  5. Click image to see an enlarged view
    Fig. Exploded view of the front disc brake assembly-Sportage
To install:
  1. Seat the caliper piston using a C-clamp.
  2. Connect the brake fluid flex line bolt to the caliper. Tighten the bolt to 17 ft. lbs. (23.5 Nm).
  3. Position the caliper over the disc assembly. Install the caliper bolts. Tighten to 72 ft. lbs. (98 Nm).
  4. Install the front wheels. Tighten the lug nuts 77 ft. lbs. (99 Nm).
  5. Bleed the hydraulic system if the flex hoses were removed.
  6. Lower the vehicle.
  1. Raise and safely support the vehicle.
  2. Remove the front wheels.
  3. Remove the 2 caliper bolts and lift the caliper from the disc.

    Click image to see an enlarged view
    Fig. Exploded view of the front disc brake assembly-Sportage
  4. Disconnect the brake fluid flex line by removing the retaining bolt if the caliper is to be replaced.
To install:
  1. Seat the caliper piston using a C-clamp.
  2. Connect the brake fluid flex line bolt to the caliper. Tighten the bolt to 17 ft. lbs. (23.5 Nm).
  3. Position the caliper over the disc assembly. Install the caliper bolts. Tighten to 72 ft. lbs. (98 Nm).
  4. Install the front wheels. Tighten the lug nuts 77 ft. lbs. (99 Nm).
  5. Bleed the hydraulic system if the flex hoses were removed.
  6. Lower the vehicle.
  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Raise and safely support the vehicle.
  3. Remove the front wheels.
  4. Remove the 2 caliper bolts and lift the caliper from the disc.

    Click image to see an enlarged view
    Fig. Exploded view of the front disc brake assembly
  5. Disconnect the brake fluid flex line by removing the retaining bolt if the caliper is to be replaced.
To install:
  1. Seat the caliper piston using a C-clamp.
  2. Connect the brake fluid flex line bolt to the caliper. Tighten the bolt to 17 ft. lbs. (23.5 Nm).
  3. Position the caliper over the disc assembly. Install the caliper bolts. Tighten to 13 ft. lbs. (17 Nm).
  4. Install the front wheels. Tighten the lug nuts 77 ft. lbs. (99 Nm).
  5. Bleed the hydraulic system if the flex hoses were removed.
  6. Lower the vehicle.

This will help.
Thanks.

See below latest solved car problems :-----

AUTOMOTIVE EMISSIONS?

http://schematicsdiagram.blogspot.com/2011/12/automotive-emissions.html

AIR POLLUTION?

Loud rattle noise from right rear portion of the car?

http://technoanswers.blogspot.com/2012/01/loud-rattle-noise-from-right-rear.html

Now Voltage at O2 sensor on 1996 Toyota Land Cruiser?

http://repairhelpcenter.blogspot.com/2012/01/now-voltage-at-o2-sensor-on-1996-toyota.html

Bank 2 Sensor 1 Heater circuit Failure?

http://schematicsdiagram.blogspot.com/2011/12/bank-2-sensor-1-heater-circuit-failure.html

Left bank sensor running lean?

http://repairhelpcenter.blogspot.com/2011/12/left-bank-sensor-running-lean.html

Rear view mirror fitting details for 2008 Toyota FJ Cruiser?

http://repairhelpcenter.blogspot.com/2012/01/rear-view-mirror-fitting-details-for.html

GPS not charging in car?

http://schematicsdiagram.blogspot.com/2012/01/gps-not-charging-in-car.html

How to remove passenger side head rest on 2007 Toyota Avalon?

http://repairhelpcenter.blogspot.com/2012/01/how-to-remove-passenger-side-head-rest.html

Where is OBD-II Connector located on the 2007 Lexus rx 400h?

http://repairhelpcenter.blogspot.com/2012/01/where-is-obd-ii-connector-located-on.html

Car cranks, then run for second and then quit?

http://repairhelpcenter.blogspot.com/2011/12/car-cranksthen-run-for-second-and-then.html

How to replace Starter on Infiniti Q45?

http://schematicsdiagram.blogspot.com/2011/12/how-to-replace-starter-on-infiniti-q45.html

Where is Radio Fuse located on 2007 Dodge charger?


http://schematicsdiagram.blogspot.com/2011/12/where-is-radio-fuse-located-on-2007.html

Relearn Theft deterrent module?

http://technoanswers.blogspot.com/2012/01/relearn-theft-deterrent-module.html

Buick theft deterrent module Relearning?

http://howtobyme.blogspot.com/2012/01/buick-theft-deterrent-module-relearning.html

2006 Ford Expedition radio not powering ON?

http://technoanswers.blogspot.com/2012/01/2006-ford-expedition-radio-not-powering.html

Ticking noise at the top end on Toyota Tundra?

http://repairhelpcenter.blogspot.com/2012/01/ticking-noise-at-top-end-on-toyota.html

Ford F350 Suddenly quit running while driving?

http://technoanswers.blogspot.com/2012/01/ford-f350-suddenly-quit-running-while.html

Trunk button Not Working on Buick car?

http://schematicsdiagram.blogspot.com/2011/12/trunk-button-not-working-on-buick-car.html

max