Friday, January 27, 2012

Replacing Wheel Speed Sensor Rotors on Kia Sportage?

The details are as follows :----


Removal & Installation



Front
  1. Raise and safely support the vehicle.
  2. Remove the appropriate tire and wheel assembly for access.
  3. Remove the brake rotor.
  4. Following proper procedures remove the wheel bearing hub assembly.
  5. Place the hub assembly on a suitable work surface.
  6. Using an appropriate puller, remove the sensor rotor from the hub assembly and discard.
    NOTE
    Do not attempt to re-use a sensor rotor once it has been removed.
To install:
  1. Position the sensor rotor on the hub and using a hydraulic press or an appropriate press tool, press the rotor onto the hub assembly.
  2. Following proper procedures install the wheel bearing hub assembly.
  3. Install the brake rotor.
  4. Install the wheel assembly and tighten the lug nuts 77 ft. lbs. (104 Nm).
  5. Lower the vehicle.

    Click image to see an enlarged view
    Fig. Remove the sensor rotor ring from the hub assembly as shown
Rear
The rear sensor rotor is not serviceable. If the rotor or rotor teeth are damaged, replace the differential gear case assembly.


This details will help.
Thanks.

See latest solved car problems :----

Parking light stay on constantly?

http://repairhelpcenter.blogspot.com/2012/01/parking-light-stay-on-constantly.html

Engine hard to start after gas refill?

http://repairhelpcenter.blogspot.com/2012/01/engine-hard-to-start-after-gas-refill.html

How to replace wheel bearing on Honda Civic?

http://repairhelpcenter.blogspot.com/2012/01/how-to-replace-wheel-bearing-on-honda.html

Do snow tires go on the back or front?

http://howtobyme.blogspot.com/2012/01/do-snow-tires-go-on-back-or-front.html

Where is Key chip memory located on 2004 ford Freestar?

http://technoanswers.blogspot.com/2012/01/where-is-key-chip-memory-located-on.html

How to fill Brake line antifreeze on freightliner classic?

http://technoanswers.blogspot.com/2012/01/how-to-fill-brake-line-antifreeze-on.html

Orange O/D warning light flashing on dash?

http://repairhelpcenter.blogspot.com/2012/01/orange-od-warning-light-flashing-on.html

GMC ENVOY spare tire system stopped working?

http://repairhelpcenter.blogspot.com/2012/01/gmc-envoy-spare-tire-system-stopped.html

Car starts and cuts off immediately?

http://repairhelpcenter.blogspot.com/2012/01/car-starts-and-cuts-off-immediately.html

Where is ECM located on 1997 Ford Ranger?

http://technoanswers.blogspot.com/2012/01/where-is-ecm-located-on-1997-ford.html

How to Attach the front bumper cover to the fender on 2010 Ford Explorer?

http://technoanswers.blogspot.com/2012/01/how-to-attach-front-bumper-cover-to.html

Ford Pickup Alarm will not disengage?

http://technoanswers.blogspot.com/2012/01/ford-pickup-alarm-will-not-disengage.html

Heater blows intermittently and temp gauge goes erratic?

http://technoanswers.blogspot.com/2012/01/heater-blows-intermittently-and-temp.html

Temperature gauge does not move and no heat when heater is ON?

http://technoanswers.blogspot.com/2012/01/temperature-gauge-does-not-move-and-no.html

Temperature gauge keeps fluctuating up and down close to red?

http://technoanswers.blogspot.com/2012/01/temperature-gauge-keeps-fluctuating-up.html

How to remove Chevy idler arm?

http://howtobyme.blogspot.com/2012/01/how-to-remove-chevy-idler-arm.html

Ford explorer will not start after replacing computer ECM ?

http://technoanswers.blogspot.com/2012/01/ford-explorer-will-not-start-after.html


max