Wednesday, February 8, 2012

1994 ford E150 Timing problem?

Timing problem can be repaired.
The spout connector has to be disconnected,to set the timing again.
The SPOUT connector is taped to the harness coming from the Ignition module on the Left inner fender.
See the diagram shown below :----


The spout connector is a small square shaped plastic piece in a little plastic connector. It has some electrical tape around it, and it is pushed into a small hole in the fenderwell. You have to disconnect this to set the timing because it takes the computer out of the loop. If you do not disconnect it you will not get an accurate timing reading because the mark on the balancer will bounce around. 

This details will help.

See below latest solved car problem:-----

Exclamation indicator light on ford freestar dash?

2004 ford freestar van idles rough?

How to remove Intake Manifold Tuning Valve?

CMFI details for GMC vehicles?

Mazda MPV cranks but will not start?


Freightliner fl112 fuse box diagram?

Car will not turn the ignition to start?

Car only starts when gas pedal is pressed?

Hyundai coupe f2 hazard fault?

Where is the bulb located in glove box?

Additional wiring harness needs to be installed in a brake controller for electric brakes on 2012 Toyota Highlander?

Fail smog test due to gas filter hose?

Clutch squeaking under hood?

Engine stalls when gas is given?

1990 mazda 323 stalls and quit running?

Nissan car will not start?

Honda car will not start intermittently?

Toyota car will not start?