Monday, February 6, 2012

Cruise control stop working on 1994 Ford ranger?

There are few possibilities,which can cause this problems,
The first thing to check is that the brake lights are working. If the brakes lights don't work the cruise will not engage. Second is check the secondary brake switch located near the normal brake light switch. This switch is a vacuum switch and if it is not adjusted properly removes vacuum from the servo. Third is check the clutch switch, also electrical like the brake light switch. Make sure you have vacuum to the servo and the cable is good from the servo to the throttle.

This details will help.

See below latest solved car problems :----

Exclamation indicator light on ford freestar dash?

2004 ford freestar van idles rough?

How to remove Intake Manifold Tuning Valve?

CMFI details for GMC vehicles?

Mazda MPV cranks but will not start?


Freightliner fl112 fuse box diagram?

Car will not turn the ignition to start?

Car only starts when gas pedal is pressed?

Hyundai coupe f2 hazard fault?

Where is the bulb located in glove box?

Additional wiring harness needs to be installed in a brake controller for electric brakes on 2012 Toyota Highlander?

Fail smog test due to gas filter hose?

Clutch squeaking under hood?

Engine stalls when gas is given?

Nissan car will not start?

Honda car will not start intermittently?

Toyota car will not start?